Zeroing the Mass Flow Controller (MFC) on the MA-3000 (ver 2)
This attached PDF will explain the procedure to zero, or re-zero, the mass flow controller, or MFC, of the MA-3000.
You will need to disconnect the gas line from the instrument before starting this procedure, but the instrument will remain powered on.
Related Articles
MA-3000 (ver 1) Flow Meter Cleaning
The attached PDF will demonstrate how to disassemble and clean the flow meter on the MA-3000. The orientation when reassembling is important The front of the meter has writing that faces forward, the clear window is oriented towards the front, and ...MA-3 Solo Flow Sensor Replacement
How to install new flow sensor 1. Remove 8 screws and remove front cover 2. Remove old flow sensor 3. Attach new flow sensor. Connect with CN20 and CN24. Put back front cover and check flow rate.MA-3000 (ver 2) Removal and Cleaning of V3 Valve
The attached PDF will explain how to remove and clean the V3 valve on the MA-3000. After cleaning the V3 Valve the mass flow controller should be re-zeroed Here are the instructions to re-zero the mass flow controllerMA-3000 Price List with Pictures
The attached PDF file contains the part numbers, prices and frequency of replacement for the most common parts for this mercury analyzer. To place an order, please send an email to orders@agssci.com or call us at (979) 320-0052.HT-300A Touch and Plunger Zero
The attached PDF will explain how to zero the plunger on the HT-300A autosampler for the PE-1000.