HT-300A Touch and Plunger Zero

• Related Articles

• PE-1000 Syringe Cleaning

  The attached PDF will explain the best way to remove and clean the syringe on the PE-1000 and explain how to re-install and position the new syringe.

• HT-300A Borders Markout Procedure

  The attached PDFs will explain the boundaries/borders markout procedure for the HT-300A autosampler for the PE-1000.  If the instructions for one of the attached files does not allow entry into the Borders Markout, then try the other file, as some ...

• PE-1000 Injection Setup and Alignments

  The attached PDF will walk you through the proper setup and settings for the autosampler injection into the PE-1000.

• PE-1000 Troubleshooting Chart

  Problem Cause Solution There is leak T-joint is loose Tighten t-joint Other joints are loose Tighten joints Sample heating tube is broken Replace sample heating tube Sample inlet nut is loose Tighten sample inlet nut Septum is faulty Replace to new ...

• PE-1000 User's Manual

  Attached is a PDF of the PE-1000 User's instrument and software instruction manual. Maintenance and troubleshooting procedures for the PE-1000 can be found in this manual.