MA-3000 (ver 1) Flow Meter Cleaning
The attached PDF will demonstrate how to disassemble and clean the flow meter on the MA-3000.
The orientation when reassembling is important
The front of the meter has writing that faces forward, the clear window is oriented towards the front, and the white
housing piece is oriented to the back
Related Articles
MA-3000 (ver 2) Removal and Cleaning of V3 Valve
The attached PDF will explain how to remove and clean the V3 valve on the MA-3000. After cleaning the V3 Valve the mass flow controller should be re-zeroed Here are the instructions to re-zero the mass flow controllerRA-4 Low Flow Error
If you are getting a "Low Flow Error" on your RA-4300A system there are three main likely causes. A leak, a restriction, or a problem with the air pump. It should be noted, if you have recently changed and parts, or have done any maintenance to any ...Zeroing the Mass Flow Controller (MFC) on the MA-3000 (ver 2)
This attached PDF will explain the procedure to zero, or re-zero, the mass flow controller, or MFC, of the MA-3000. You will need to disconnect the gas line from the instrument before starting this procedure, but the instrument will remain powered ...MA-3 Solo Flow Sensor Replacement
How to install new flow sensor 1. Remove 8 screws and remove front cover 2. Remove old flow sensor 3. Attach new flow sensor. Connect with CN20 and CN24. Put back front cover and check flow rate.MA-3000 Teflon Joint and Flowcell cleaning
(1) Remove the teflon joints and disassemble the flowcells (Instructions for disassembling flowcells) (2) Put all the teflon joints and flowcell components in a beaker (3) Pour a neutral detergent in the beaker until all parts are completely covered ...