RA-5 Update from Internal Tablet to External PC

RA-5 Update from Internal Tablet to External PC

Easy Configuration - Estimated time of 20 minutes

1. Open the RA-5
2. Remove the tablet from the front panel
3. Remove the USB connection of the tablet from the left board
4. Remove one of the USB connections from the USB Conversion Port located on the lid
5. Put the USB cable in the now empty USB port (refer to attached photo)



Software (With the RA-5 on and RA-5 Program Software Loaded onto the PC)
1. Plug the Male-to-male USB cable from the PC to the corresponding external USB port on the RA-5
2. Open the Driver software on the USB flash drive which came with the system.
3. Run the corresponding software for Windows. Windows 64 bit or Windows 32 bit. (How to confirm Windows is below)
4. Under Device Manager, make sure the computer recognizes the port under "Ports" and make note of the COMX number
5. Open the RA-5 Program Software, navigate to settings, Com Port, make sure the Com Ports correspond
6. Close the RA-5 software and Re-Open the software to establish communication and resume operation



Windows 10 and Windows 8.1

  1. Select the Start  button, then select Settings > System > About .
  2. At the right, under Device specifications, see System type.

Windows 7

  1. Select the Start button 
    The Start button
    , right-click Computer, and then select Properties.
  2. Under System, see the system type.

    • Related Articles

    • RA-5 User's Manual

      The attached PDF is the Model RA-5 User Operational and Maintenance instrument and software manual. The maintenance procedures for the RA-5 can be found in the manual.

    • RA-7 Series Firmware and Software Updates

      Please follow these instructions in the exact order listed below to update the firmware and software for the RA-7 Series Mercury Analyzers. If at any time there are unforeseen errors or questions, please contact our technical support department at ...

    • RA-4300FG+ Firmware Update Instructions

      The attached PDF will explain the procedure to updating the firmware on the RA-4300FG+. Do not update the firmware unless instructed to do so by a service engineer.  Many firmware versions are not compatible with different software versions

    • READ FIRST - RA-4300FG Update Instructions - Dec 2020

      1 West Bronze Lane Bryan, TX 77807 Toll Free: 1.877.247.7241 Direct: 979.320.0052 Web: www.agssci.com Software & Firmware Upgrade Instructions NIC Model RA-4300FG+ Mercury Analyzer The following instructions are to be used to upgrade the NIC software ...

    • Model RA-3320 User's Manual

      The attached PDF is the Model RA-3320A and RA-3310A Instrument and software user's manual. Maintenance and troubleshooting procedures for the RA-3320 can be found in this manual.