MA-3000 Autosampler Adjustment

Open Maintenance Tab and select "BC" Tab; then select BC Adjust.  The Password is 0219 

Place an empty boat in one of the positions in a rack.  You will now follow the on-screen instructions to make the necessary adjustments to the sampler.  You will advance one step at a time by following the menu legend below.  

• Related Articles

• MA-3000 Autosampler Lift Adjustment

  This procedure should only be performed after speaking with a service technician 1. Remove the entire Tray Holder assembly by removing the 4 screws in the corners 2. Adjust the motor position by centering the shaft by loosening two screws (yellow ...

• RA-4300 Autosampler Arm Adjustment

  This procedure can be used to adjust the arm so that it is properly sealing on the sample test tubes RA-4300 Autosampler Adjustment 1. Power on the RA-4300 and open the software 2. Open Run→Maintenance 3. Place a blank tube in position 1, 47, and 77 ...

• PE-1000 Autosampler Turret adjustment

  The attached PDF is a document that can be used to adjust the position of the turret on the autosampler.

• SC-3 Autosampler Alignment

  Pre-Checks 1. Looking down on the autosampler head, there are two screws that go through metal springs  and attach to the cap.  Ensure that they are snug, but do not strip them. 2. Run a few tests sample runs to see if there is a consistent pattern ...

• SC-3 Autosampler Alignment Adjustment

  Pre-Checks 1. Looking down on the autosampler head, there are two screws that go through metal springs and attach to the cap.  Ensure that they are snug, but do not strip them. 2. Run a few tests sample runs to see if there is a consistent pattern of ...