PE-1000 Injection Setup and Alignments
The attached PDF will walk you through the proper setup and settings for the autosampler injection into the PE-1000.
Related Articles
HT-300A Borders Markout Procedure
The attached PDFs will explain the boundaries/borders markout procedure for the HT-300A autosampler for the PE-1000. If the instructions for one of the attached files does not allow entry into the Borders Markout, then try the other file, as some ...
HT-300A Touch and Plunger Zero
The attached PDF will explain how to zero the plunger on the HT-300A autosampler for the PE-1000.
PE-1000 Septum Replacement
1) Loosen the joint on the right side and disconnect the joint from the metal branch 2) From the top of the system, use one hand to apply gentle pressure straight down onto injection plate. It is important not to rock the inlet because it may break ...
PE-1000 User's Manual
Attached is a PDF of the PE-1000 User's instrument and software instruction manual. Maintenance and troubleshooting procedures for the PE-1000 can be found in this manual.
PE-1000 Lamp Replacement
The attached PDF may be used to replace, or exchange, the lamp in the PE-1000 instrument. This procedure was taken directly from the manual. You can find the manual here.