MA3000 H3 Heater Replacement Instructions

The Attached PDF has instructions for replacing the H3 heater on the MA3000.

• Related Articles

• MA-3000 H2 Heater Replacement Instructions

  MA-3000 H2 Heater Replacement Instructions These instructions are for units with Serial# 12740141 and greater, please check your serial number to confirm these are the correct instructions Inside of the MA-3000 is at a very high temperature. Please ...

• H2 Heater Coil Check

  The attached PDF displays the test points and proper readings to determine if your H2 heater needs to be replaced.  All these test points need to be measured with the instrument off, cooled down, and the instrument disconnected from power.   The ...

• PE-1000 H5 Heater Thermocouple Replacement

  The attached PDF will explain the procedure to replace the thermocouple on the H5 heater on the PE-1000. ​

• MA-2000 LAMP REPLACEMENT and/or ADJUSTMENT

  This procedure will walk you through how to replace the lamp on the MA-2000.  It can also be used if the lamp needs to be adjusted for correct voltage readings. 1. Open the front of the system  2. Open the optics box  3. Remove the cell, tubing, etc. ...

• MA3000 H3 Heater and Gold Trap Positioning

  The attached PDF article will demonstrate the proper placement of the gold trap within the H3 heater coil as well as demonstrate the proper placement of the thermocouple on the heater coil. Please note the thermocouple is wrapped around the eighth ...