MA3000- Cleaning the Cell

MA3000- Cleaning the Cell

The attached PDF can be used to disassemble and clean the flowcell(s) on the MA-3000.


Please note there are 2 generations of the MA-3000, the instructions are slightly different according to the version you have, pay special attention to the order of assembly with the end glass pieces, o-rings, and screws.


    • Related Articles

    • MA-3 Solo Detector Flowcell Removal and Cleaning Instructions

      The attached PDF are the instructions to remove, disassemble, and clean the detector flowcell of the MA-3 Solo instrument.
    • RA-4500 Flowcell Cleaning

      This procedure will explain how to clean the detector flowcell on the RA-4500 system. First, open the optical system box, and remove the four screws holding the cell in place. Remove the tubing from the inlet and exit and remove the flowcell assembly ...
    • Cleaning the flowcell on the RA-4300A

      This procedure will explain how to clean the detector flowcell on the RA-43000A system. First, open the optical system box, and remove the four screws holding the cell in place. Remove the tubing from the inlet and exit and remove the flowcell ...
    • RA-4300FG+ Flowcell Cleaning

      Disconnect the Teflon joints of the AFS optical system, and loosen the four screws fixing the cell (in the red circles).    Also loosen the three screws on the left side (in the blue circles).  Remove the plates. Remove the Teflon connection on the ...
    • MA-3000 Teflon Joint and Flowcell cleaning

      (1) Remove the teflon joints and disassemble the flowcells (Instructions for disassembling flowcells) (2) Put all the teflon joints and flowcell components in a beaker (3) Pour a neutral detergent in the beaker until all parts are completely covered ...