Related Articles
RA-3 Carrier Pump Test
There are various reasons for a non-functioning air pump. 1. To verify if the pump functions a. Open the maintenance screen on the RA-3 b. In an alternating pattern, press on the top left and top right corners of the touch screen, which ...
Replacing the Reagent Pump Motor on the RA-4 Series
1) Power OFF the analyzer. 2) Remove the right side panel of the RA-4 (side with power switch) by removing the Phillips screws in the exterior of the side and then the hex screws on the inside of the panel. 3) Remove the reagent pump head of the ...
MA-3000 H2 Heater Replacement Instructions
MA-3000 H2 Heater Replacement Instructions These instructions are for units with Serial# 12740141 and greater, please check your serial number to confirm these are the correct instructions Inside of the MA-3000 is at a very high temperature. Please ...
MA-3000 Lamp Replacement Procedure
With the power off, open the optics cover, and remove the bracket that holds the lamp assembly to the chassis, and unplug the electrical connections from the board. Before going any further, note the orientation of the lamp. If needed, mark on the ...
PE-1000 PMT Replacement
How to replace PMT Remove 4 black screws. (red circles) Disconnect elbow joint and T-joint. (blue circles) | Remove optical box Remove 6 screws from back side Pull out PMT box and remove 4 screws | | | Pull out PMT and the socket Pull out ...