AGS Scientific, Inc. | Locating Leaks

Locating Leaks
Locating Leaks on RA-4300FG+
This article is to be used when a leak is found on the RA-4300FG+, and the tightening of fittings does not resolve the issue. 1) Locate the 4mm (outer diameter) tubing that was supplied with the RA-4300FG+. It is the same size as the tubing used ...

Popular Articles
Removing Combustion Tube - MA3000
Removing the Combustion Tube Carry out maintenance of the heated sections only after the power switch has been turned OFF and the heater has cooled down to room temperature or it could result in burns. 1. With the power off remove the top cover and ...
H2 Heater Coil Check
The attached PDF displays the test points and proper readings to determine if your H2 heater needs to be replaced. All these test points need to be measured with the instrument off, cooled down, and the instrument disconnected from power. The ...
RA-4500 User's Manual
The attached PDF is the User's Instruction and Operational Manual for the RA-4500 instrument and software. Most of the maintenance procedures for the RA-4500 are in this manual.
Preparing Trace Level Calibration Standards
These instructions are specifically for preparing mercury standards at trace levels for the NIC RA-4300FG+ and previous models. These instructions will only work with the NIC direct purge systems and are not intended for use with other analyzers. ...
MA-3000 Combustion Tube Removal Video
The following link is an instructional video on how to remove the MA-3000 Combustion Tube (aka Catalyst Tube). MA-3000 Combustion Tube Removal Video

AGS Scientific, Inc. | Locating Leaks | Knowledge Base